_code: 21231

1. If there is a COM_CHIP_BIG on the bomb, pull out FLAT WIRE BOTTOM.
2. If the MAIN BUTTON is off, turn it on.

_code: 22085

1. If there's an orange cable connected to the bomb, remove BATTERY CABLE.
2. Remove FUSE in this order: FUSE1, FUSE3, FUSE2 (if any of the FUSEs are missing, skip removing it).
3. If the FUSE PANEL SERIAL NUMBER is in the list on the:
	1st - 5th spot, remove the red cable.
	6th - 10th spot, remove the yellow cable.
	11th – 20th spot, turn off the TRANSFORMER (press the TRANSFORMER BUTTON if the red LED is blinking).
4. Remove COM_RESISTOR collored light grey, dark grey, light grey and black from the COVERBOX.

_code: 23212

1. Remove COM_CHIP_BIG.
2. If the bomb contains a COM_TRANSISTOR_BROWN remove COM_TRANSISTOR_YELLOW.
3. Enter the sequence 12512.
4. Turn off MAIN_BUTTON.
5. If the bomb has more than 1 FUSE, remove COM_CHIP_SMALL_3 FROM the COVERBOX.

_code: 26281

1. Set ROTARY_SWITCH_BROWN to 6.
2. If the bomb has a BATTERY_AA remove FLAT_WIRE_TOP and then FLAT_WIRE_BOTTOM.
3. If the BOMB SERIAL NUMBER is type A or C, pull out the ANTENNA. If the BOMB SERIAL NUMBER is type B, pull out BATTERY_AA.
4. Remove DIAL_BATTERY_CABLE.
5. Remove a green cable if it leads from a slot marked with two dots.